Print Supplies
Print Supplies
-
eSUN 3mm Light Blue PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs) Actual Diameter 2.85mm +/- 0.05mm Light Blue (Pantone 306C) IG-C-PLAPRO300D1$24.49This is 3mm/2.85mm filament. Please make sure your printer can support 2.85mm filament before buying this filament. This filament does not support 1.75mm 3D printers such as CR-10, FlashForge, Wanhao, MakerGear, Monoprice select and Prusa. This filament supports all 2.85mm open standard 3D printers such as Lulzbot and Ultimaker. Verify your printer before purchasing to avoid unnecessary returns.eSUN 3D Printer Filament: PLA PRO Size: 3mm nominal, 2.85 +/-0.05mm actualExtrusion Temperature Range: 210 to 225 Celsius PLA PRO(PLA+) Advantages: Superb layer bonding High rigidity. Good glossiness. Several times tougher than PLA Smoother finished printouts. No cracking or brittle problem. PLA PRO prints about 20 Celsius higher than regular PLA and produces strong products. Learn More
-
Monoprice PLA 3D Printer Filament - Light Blue - 0.5kg Spool 1.75mm Thick | | For All PLA Compatible Printers 114380$15.70 $15.70Get outstanding 3D printing results when you use 1.75mm PLA 3D Printer Filament from Monoprice! PLA is a good choice for a printing material if you are looking for high accuracy and high resolution. It extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0.3%). PLA is harder than ABS, but is therefore also a bit more brittle. This 0.5 kg spool features a thickness of 1.75mm ±0.05mm. It has a nominal processing temperature of 180 ~ 210°C (356 ~ 410°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament. The negatives of using PLA is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and drooping if it gets too hot. Learn More
-
eSUN 1.75mm Light Blue PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs) Light Blue IG-C-PLAPRO175D1$21.99eSUN 3D Printer Filament: PLA PRO Color: Light BlueExtrusion Temperature Range: 205 to 225 PLA PRO(PLA+) Advantages: Superb layer bonding High rigidity. Good glossiness. Several times tougher than PLA Smoother finished printouts. No cracking or brittle problem.Prints are hard to break. PLA PRO(PLA+) print temperature is about 20 Celsius higher than regular PLA. Most users print at around 210 to 215 Celsius. Other settings are about the same.INTSERVO is dedicated to customer satisfaction. Customers are always welcome to contact us for any questions and/or support needs. Learn More